I decided to install a rick controller (Motorola HLN3333B Repeater controller)

 and find the pins for use with

Motorola mcs2000 radios (since rick controller works only with m100 or so,) I have to figure the pin out (no info out there) so I  have a working good repeater now, with the help of a oscilloscope.

well I used a radio on the input of the controller to check the pins for  audio level, (finding the output on the other connector).

the tail  too, and figure out  the circuit (kind of),

remember Motorola rick controller doesn't have ptt id.(that's and extra stuff I add).

Motorola mcs2000 radio to radio connection diagram.

 (that's why I use Motorola rick).

and it was cheaper too,

remember this mcs2000 radios are 24 and 48 watts and require a

14 amps on hi and 8 amp on low 13.8v

this is what I end up, it works good.

in the bottom is the internal dip switches final order

for a 3 sec tail..

NOTE: open images on new tab to see it bigger size,🙂

this is what I end up, it works good.    

there's more to add,  but for now is good....

future topics:

programing radio and software setup,

fixing blow final transistor.

adding remote controller to rick Motorola,

ptt id for repeater tx radio (all this page is Motorola mcs2000). 

I will put a link for email if you have questions, 

👍

click here for email

click here for something else  😀

REMOVE TOP ANTENNA AND CALIBRATE  BOTTOM ANTENNA WITH MIDDLE COIL ON..

SECOND  STEP INSTALL (SCREW) TOP ANTENNA AND CALIBRATE AGAIN